Standardization of offset printing

Standardization of offset printing divides the entire technological production process into nodes where you can carry out control and thus fully control the accuracy and repeatability of production in accordance with international and industrial standards.

cmp offset
offset

Prepress - preparation for printing

  • Calibration or implementation of a proofing system
  • Stabilization of the flow of information about the image (production files, saving)
  • Calibration of monitors

 

Plate making - control of the CTP plate manufacturing process

  • Assessment of the stability of the CTP system operation,
  • Selection of screening parameters to the nature of production and workflow possibilities,
  • System linearization

Press - print

  • Lighting audit at the print assessment site in accordance with ISO ISO 3664: 2009
  • Mechanical audit of the printing machine, mechanical control of the selection of roller clamps, the angle of the doctor blade
  • Selection of the optimal formula of paints based on a mono-pigmented base
  • Optimization of variable parameters affecting printing, predicting their behavior at the standardization stage, e.g. printing support parameter
  • Determination of the spectral parameters of Lab CMYK / RGB printing in accordance with ISO 12647-4: 2014
  • Determination of TVI correction curves, data averaging according to ISO 12647-4: 2014
  • Verification of the correctness of the settings with the gray balance test
  • Determination of ICC profile, Device Link, optimization of the maximum inking on the machine
  • Spectral and optical assessment of compliance with the proof (proof copy)
  • Measurement of the gloss of the substrate